Ce Certified Glazed Cold Tile Roll Forming Machine for Roof
STWYX15-225-900
Components:
- The uncoiler and its base
- Coil sheet guiding and adjusting equipment
- Film covered device
- Main roll forming system
- Post- Cutting device
- Hydraulic station
- PLC control System
- Support table
Material of Roll former system:
- Roller: High grade No. 45 forged steel, plated hard chromed on the surface of rollers with thickness 0.05mm.
- Active shaft material: High grade No. 45 carbon wrought steel at diameter 75mm.
- Cutting blade: Cr12 mould steel with quenched treatment.
Working flow:
Decoiling the sheet- - - Guiding the sheet- - - Covering the film- - - Roll forming- - - Measuring the length- - - Cutting the panel- - - Panels to the supporter.
Our machine's warranty time:
We offer 12 months quality grantee time starting from the date of delivery. When delivery, we will ship a set of wearing parts for free; Within the warranty period, maintenance of equipments and replacement of parts of equipment are charge-free.
After-sale service:
We offer sale after service for life. The machine will be inspected well in our workshop before delivery. We will send one technician to your factory to install the machine if you need extra installation, training service; The seller should arrange offer technical back-up and assign a technician people to the buyer's part.
No. |       item | Parameter(all is subject to our final design) | |
1 Â |
Suitable raw material | Type | Common galvanized & pre-painted steel |
Yield strength | 235MPa(or other high strength steel) | ||
Thickness(mm) | 0.4-0.7 | ||
width(mm) | According to final design | ||
2 | Manual uncoiler's capacity | Max.5tons | |
3 | Forming speed(m/min) | About 18-20m/min | |
4 | Main motor power(KW) | 7.5kw | |
5 | Hydraulic power(KW) | 3kw | |
6 | Forming roller groups | Around19-20 groups | |
7 | Raw material of forming roller | High quality No.45 steel | |
8 | Raw material of cutting blade | Cr12mould steel with quenched treatment | |
9 | controlling system | Mitsubishi PLC& converter | |
10 | Suitable industrial voltage |  According to your special requirement | |
11 | Machine dimensions(L*W*H) | 6.8m×1.8m×1.52m | |
12 | Machine weight | About 9-10tons |
Tube sheet are usually made of a round flat plate with holes drilled into the plate to accommodate tubes in the exact location and pattern relative to each other. The tube sheet is used to support and isolate the tubes in the Shell And Tube Heat Exchanger.
A tube sheet is a plate used to support a tube in a shell and tube heat exchanger. The tubes are aligned in a parallel manner and are supported and held in place by the tube plate. A tube sheet is a round plate with holes in it so that the tube can fit through the opening. Tubes are usually made of round, flat metal sheets. Drill holes for pipe ends in precise locations and patterns relative to each other. The tube plate is made of the same range of materials as the pipe.
These are usually made of mild steel and vary in thickness according to fluid pressure. Depending on the final application (petrochemical, nuclear, oil and gas, etc.), the tubes can be clad in stainless steel or other superalloys, or even made entirely of stainless steel or superalloys.
Tube Sheet,Boiler Tube Sheet,Floating Tubesheet,Exchanger Tube Sheet
Guangdong Jiema Energy Saving Technology Co.,Ltd , https://www.heatexchangerjm.com