One-step drying dryer for sodium gluconate was successfully developed
This series of equipment can regenerate various types of activated carbon such as coal, wood, nut shell, mineral (petroleum), or powder, granule, column, or primary, extruded, and re-formed activated carbon, according to the characteristics of activated carbon fire method regeneration treatment , This series of equipment is equipped with unique flue gas treatment equipment to ensure the green and environmental protection of the activated carbon fire method regeneration process.
After years of development and application, the market coverage of this series of equipment has been very extensive, and currently covers many fields such as gold mines, food and pharmaceuticals, urban water supply, petrochemicals, coal chemicals, smelting industry, fine chemicals and wastewater treatment.
Carbon Regeneration Machine,Gold Rotary Kiln,Carbon Rotary Kiln,Chemical Rotary Kiln Changchun Gold Research Institute Co.LTD , https://www.changchungoldresearch.com
The national high-tech enterprise Changzhou One-Step Drying Equipment Co., Ltd. has developed a special drying machine for sodium gluconate drying process, which has been sold to Zhejiang Tianyi Food Additives Co., Ltd. and is operating normally.
The XF series boiling dryer was used for this special dryer. The industry standard of this series of products was drafted and released by the company. It consists of an air filter, an ebullating bed main unit, a cyclone separator, a bag filter, a high pressure centrifugal fan, and an operating console. The clean hot air is distributed into the bed through the valve plate. The wet material entering the feeder is boiled by the hot air. Because the hot air is in contact with the material, the process of heat and mass transfer is enhanced, and therefore it can be dried in a short time. If the continuous type is adopted, the material enters from one end of the bed and is boiled and dried after tens of seconds to several minutes, and flows out from the other end of the bed automatically.
The main features of this special dryer are: the fluid bed master section design, full consideration of the material fluidization, and reduction of dust entrainment, high drying efficiency; host bed board opening rate is reasonable, can avoid leakage, and fully fluidized; by the filter Modular air handling cabinets, such as heaters, are equipped with quick-opening doors that can be quickly disassembled and replaced; the entire system operates under micro-pressure and is airtight, with no flying dust and neat working environment.
The clean hot air is distributed into the bed through the valve plate, and the wet material entering from the feeder is boiled by the hot air. Due to the extensive contact of hot air with the material, the process of heat and mass transfer is increased, so it can be dried in a short time. If the continuous type is adopted, the material enters from one end of the bed and is boiled and dried after tens of seconds to several minutes, and flows out from the other end of the bed automatically.