Automatic chain lubrication method - brush lubrication
The chain mainly includes conveyor chain, transmission chain, special professional chain, pull chain and so on. Chain drives are widely used in the field of mechanical transmission. Most of the traditional chains use high-viscosity oils and greases and are applied to the surface of the chain by hand. Extensive use of lubricating oil not only wastes but also easily sticks dust, debris and other impurities on the chain, thereby increasing the friction of the chain. This will not only greatly reduce the service life of the chain, but also increase the frequency of chain replacement and increase maintenance costs. Therefore, the lubrication of the chain can not be underestimated, in addition, the traditional lubrication method will only play a certain degree of lubrication on the surface of the chain and chain, it is difficult to penetrate into the pin, bushing and roller. In fact, the failure of most chains is caused by the following factors.
Wood Hammer Mill mainly relies on impact to break the material.It has the characteristics of simple structure, large crushing ratio and high production efficiency, and can be used for dry and wet crushing.The utility model relates to a crusher which can crush the straw of grain, legumes and weed materials.Bearing table and fixed knife table of this machine are on the same plane, shorten the length of the spindle, so the structure is compact, the screen for the ladder, increase the screen packing Angle, the area of powder, so that the crushing effect is good, easy to replace the screen.
Wood Hammer Mill,Hammer Mill Machine,Biomass Hammer Mill Crusher,Grains Large Hammer Mill Jinan Shanghangda Machinery Co., Ltd. , https://www.shdmachines.com
1. When the inside of the chain is not fully lubricated, wear and corrosion are likely to occur, causing the chain to loosen or kink.
2. When the chain is running, due to the high speed, it will shake off the lubricating oil attached to the surface, so that the chain will lose the protection of lubricating oil.
3. If the chain is in operation, the environment is humid or dusty, then dust and other impurities are likely to go inside the chain and cause wear and corrosion.
In order to solve the problem of manual lubrication, Sanhe Poda recommends the use of automatic timing lubrication, combined with a good brush lubrication protection. The advantages of doing so:
1, to extend the service life of the chain.
2. Reduce downtime and downtime.
3, reduce energy loss.
4, less loss of lubricants.
5, absorb the chain vibration and shock, reduce noise.
6. Reduce the temperature of high-speed running chains.
Remove dust and impurities, etc., to better form the transmission of the oil film protection chain.