Ito generator circuit and oil circuit troubleshooting

Ito generator circuit and oil circuit troubleshooting
Ito's generator unit was found to be the most troubled place on the circuit and the oil path. In these areas, it is certainly a lot of questions. Let us give you a detailed introduction on these aspects today. I believe we can understand Ito's generator set under our introduction. The circuit and the oil circuit are solved.
When using a generator set as a power, there are often many problems in the oil circuit and the circuit. Therefore, there are many things to understand in this regard. What are the specific details? The following Ito generator manufacturers to give you a detailed introduction.
When the generator set is in use, there will be more problems, such as the quality of diesel fuel, circuit problems, and fuel system. These problems can be solved very well. Please pay attention to the following contents.
In the use of Ito generator set , if the fuel system components are leaked, the diesel filter will be blocked, the fuel advance angle is not correct, the fuel quality is poor, the moisture content is too much, or the cold water leaks into the combustion chamber. Poor atomization, lack of combustion of diesel fuel in the combustion chamber, uneven fuel supply in each cylinder of the fuel injection pump, etc. will cause the phenomenon of insufficient power in the Ito generator set.
Troubleshooting method, check the quality of diesel, diesel quality is not good, will produce the above situation, check whether the fuel system components have leaked parts, and then check the injection pump drive connection plate two fixed screw connection.
Under normal circumstances, the two fixing screws are in the middle position in each slot. If the screws loosen, it means that the power of the Ito generator set is insufficient due to the change of the fuel supply advance angle. It should be adjusted according to the specification, if the oil supply The correct lead angle should be checked next.
Remove the diesel filter element and the oil pump to check the oil filter. If the filter element and the filter are relatively clean, check the atomization quality of the fuel injector. Then find professional service personnel to calibrate the fuel injection pump.
Ito's generator manufacturers continued the topic of the last time and continued to solve the problem of 30kw Ito generators in use.
A customer consults such questions on the Internet. What is the cause of the alarm circuit of the Ito generator set unit group not working and how should it be solved? There are several reasons for the query:
1, the alarm circuit board off, damaged.
2. The alarm switch is damaged.
3, low oil pressure sensor open circuit, wire break.
4, J1, J2, J3 relay damage.
5, low oil pressure alarm circuit, light-emitting diode open circuit.
The solutions that can be implemented by the above faults:
1. Check or replace the alarm circuit board.
2, check or replace the alarm switch.
3, check or replace the low oil pressure sensor, handle wire open circuit.
4, check or replace J1, J2, J3 relay damage.
5. Check if the circuit between 528 and 524 is broken and replace the LED.
The above are just a few points that the generator set often fails. After mastering it, everyone will use the generator set for better maintenance.

Plasma Titanium Deburring Machine

Plasma Titanium Deburring Machine,Small Parts Deburring Machines,Titanium Deburring Machine,Titanium Plasma Deburring Machines

Dongguan Bayi Automation Equipment Co., Ltd , https://www.bayipolisher.com