Introduction to the use of high pressure hose
High pressure hose notes: 1. The bending radius should not be less than the given bending radius to prevent damage to the high-pressure hose skeleton or due to excessive stretching and early damage. 2. According to the conditions of use, the correct selection of high-pressure hose varieties, specifications, do not misuse or substitute. 3. When the high-pressure hose is used, the pressure should be adjusted step by step to avoid sudden pressure increase and damage the pipe body. 4. When the work place changes, it should be transported off the ground, not to mop the ground, so as not to scratch the outer layer and then corrode the skeleton layer. 5. Convey the corrosive liquid. After use, the inside should be cleaned to prevent the residue from corroding the pipe for a long time, or use the corresponding series of products. The high-pressure hose is mainly composed of liquid-resistant synthetic rubber inner rubber layer, medium rubber layer, I, II, III steel wire braiding layer and weather resistant synthetic rubber outer rubber layer. The inner rubber layer of high-pressure rubber hose has the pressure to protect the conveying medium. The steel wire is not affected by the erosion, the outer rubber layer protects the steel wire from damage, and the steel wire layer is a skeleton material, which serves as a reinforcing effect. 3Tons Electric Hydraulic Jack bearing capacity within 3 tons and 35cm lifting height, 3 In 1 Electric Hydraulic Jack,Electric Car Jack 5 Ton 12V,Electric Car Hydraulic Jack,20 Ton Electric Jack JINYUN TIANYANG TOOLS CO.,LTD. , https://www.tianyang-tool.com